EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789250504	66 Count	383 Count	42 Count
1789249903	64 Count	372 Count	41 Count
1789249303	63 Count	362 Count	41 Count
1789248702	61 Count	345 Count	40 Count
1789248101	59 Count	331 Count	39 Count
1789247501	58 Count	322 Count	39 Count
1789246900	56 Count	303 Count	38 Count
1789246300	54 Count	287 Count	37 Count
1789245699	53 Count	277 Count	37 Count
1789245098	51 Count	261 Count	36 Count
1789244498	43 Count	237 Count	29 Count
1789243897	36 Count	213 Count	23 Count
1789243296	28 Count	185 Count	16 Count
1789242696	19 Count	159 Count	8 Count
1789242095	17 Count	145 Count	7 Count
1789241494	15 Count	131 Count	6 Count
1789240894	14 Count	120 Count	6 Count
1789240293	12 Count	106 Count	5 Count
1789239693	10 Count	89 Count	4 Count
1789239092	9 Count	78 Count	4 Count
1789238491	7 Count	65 Count	3 Count
1789237891	5 Count	46 Count	2 Count
1789237290	4 Count	35 Count	2 Count
1789236689	2 Count	26 Count	1 Count
1789236089	0 Count	11 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)