EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773197549	279 Count	480 Count	143 Count
1773196949	277 Count	478 Count	142 Count
1773196348	274 Count	475 Count	140 Count
1773195747	272 Count	474 Count	139 Count
1773195147	270 Count	472 Count	138 Count
1773194546	267 Count	469 Count	136 Count
1773193946	265 Count	468 Count	135 Count
1773193345	263 Count	466 Count	134 Count
1773192744	260 Count	463 Count	132 Count
1773192144	258 Count	462 Count	131 Count
1773191543	256 Count	460 Count	130 Count
1773190942	253 Count	458 Count	128 Count
1773190342	251 Count	457 Count	127 Count
1773189741	249 Count	455 Count	126 Count
1773189140	246 Count	453 Count	124 Count
1773188540	244 Count	452 Count	123 Count
1773187939	242 Count	450 Count	122 Count
1773187339	239 Count	447 Count	120 Count
1773186738	237 Count	446 Count	119 Count
1773186137	235 Count	444 Count	118 Count
1773185537	232 Count	441 Count	116 Count
1773184936	230 Count	440 Count	115 Count
1773184335	228 Count	438 Count	114 Count
1773183735	225 Count	435 Count	112 Count
1773183134	223 Count	434 Count	111 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)