EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769954529	617 Count	123 Count	123 Count
1769952728	615 Count	122 Count	122 Count
1769950927	614 Count	122 Count	122 Count
1769949126	613 Count	122 Count	122 Count
1769947325	612 Count	122 Count	122 Count
1769945524	611 Count	122 Count	122 Count
1769943723	610 Count	122 Count	122 Count
1769941922	609 Count	122 Count	122 Count
1769940121	606 Count	120 Count	120 Count
1769916731	569 Count	96 Count	96 Count
1769914930	567 Count	95 Count	95 Count
1769913130	564 Count	93 Count	93 Count
1769911329	561 Count	91 Count	91 Count
1769909528	558 Count	89 Count	89 Count
1769907728	554 Count	86 Count	86 Count
1769905927	553 Count	86 Count	86 Count
1769904127	551 Count	85 Count	85 Count
1769902324	547 Count	82 Count	82 Count
1769900523	546 Count	82 Count	82 Count
1769898722	545 Count	82 Count	82 Count
1769895133	543 Count	82 Count	82 Count
1769893331	541 Count	82 Count	82 Count
1769889729	537 Count	82 Count	82 Count
1769887928	536 Count	82 Count	82 Count
1769886127	535 Count	82 Count	82 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)