EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789189524	44 Count	40 Count	32 Count
1789187721	39 Count	35 Count	28 Count
1789185958	34 Count	30 Count	24 Count
1789184155	29 Count	25 Count	20 Count
1789182352	24 Count	20 Count	16 Count
1789180548	17 Count	13 Count	10 Count
1789178744	13 Count	9 Count	7 Count
1789176941	7 Count	5 Count	4 Count
1789175135	1003 Count	412 Count	392 Count
1789173331	992 Count	407 Count	388 Count
1789171527	983 Count	402 Count	384 Count
1789169724	979 Count	398 Count	381 Count
1789167921	970 Count	393 Count	377 Count
1789166117	965 Count	388 Count	373 Count
1789164454	961 Count	384 Count	370 Count
1789162650	954 Count	379 Count	366 Count
1789160846	943 Count	374 Count	362 Count
1789159043	929 Count	369 Count	358 Count
1789157240	921 Count	364 Count	354 Count
1789155436	916 Count	359 Count	350 Count
1789153632	911 Count	354 Count	346 Count
1789151828	896 Count	349 Count	342 Count
1789150024	887 Count	340 Count	334 Count
1789148220	883 Count	337 Count	331 Count
1789146417	879 Count	334 Count	328 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)