EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4GMY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4GMY-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1760089262	398 Count	784 Count	279 Count
1760088359	396 Count	782 Count	278 Count
1760087455	393 Count	774 Count	276 Count
1760086552	391 Count	759 Count	275 Count
1760085649	389 Count	746 Count	274 Count
1760084745	387 Count	737 Count	273 Count
1760083842	382 Count	726 Count	269 Count
1760082939	378 Count	718 Count	266 Count
1760082035	376 Count	707 Count	265 Count
1760081132	371 Count	701 Count	261 Count
1760080228	369 Count	697 Count	260 Count
1760079325	367 Count	691 Count	259 Count
1760078502	361 Count	684 Count	258 Count
1760077598	358 Count	677 Count	256 Count
1760076695	355 Count	668 Count	254 Count
1760075792	353 Count	661 Count	253 Count
1760074888	351 Count	654 Count	252 Count
1760073985	349 Count	644 Count	251 Count
1760073081	346 Count	632 Count	249 Count
1760072178	344 Count	618 Count	248 Count
1760070371	339 Count	604 Count	245 Count
1760069468	335 Count	593 Count	242 Count
1760068565	333 Count	583 Count	241 Count
1760067661	331 Count	577 Count	240 Count
1760066758	329 Count	569 Count	239 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)