EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6QKX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6QKX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1761646731	2 Count	0 Count	0 Count
1761646615	2 Count	0 Count	0 Count
1761646532	2 Count	0 Count	0 Count
1761646220	0 Count	0 Count	0 Count
1761643375	855 Count	23 Count	12 Count
1761641507	853 Count	23 Count	12 Count
1761637897	851 Count	23 Count	12 Count
1761634287	849 Count	23 Count	12 Count
1761630677	847 Count	23 Count	12 Count
1761627067	845 Count	23 Count	12 Count
1761623457	843 Count	23 Count	12 Count
1761619847	841 Count	23 Count	12 Count
1761616237	839 Count	23 Count	12 Count
1761612627	837 Count	23 Count	12 Count
1761609018	835 Count	23 Count	12 Count
1761605407	833 Count	23 Count	12 Count
1761601797	831 Count	23 Count	12 Count
1761598188	829 Count	23 Count	12 Count
1761594578	827 Count	23 Count	12 Count
1761590968	825 Count	23 Count	12 Count
1761587358	823 Count	23 Count	12 Count
1761583748	821 Count	23 Count	12 Count
1761580139	819 Count	23 Count	12 Count
1761576529	817 Count	23 Count	12 Count
1761572919	815 Count	23 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)