EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP6EFY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6EFY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1745160228	669 Count	937 Count	669 Count
1745156628	661 Count	925 Count	661 Count
1745153028	653 Count	913 Count	653 Count
1745149428	645 Count	901 Count	645 Count
1745145827	637 Count	889 Count	637 Count
1745142227	629 Count	877 Count	629 Count
1745138627	621 Count	865 Count	621 Count
1745135027	613 Count	853 Count	613 Count
1745131425	607 Count	845 Count	607 Count
1745127825	603 Count	841 Count	603 Count
1745124225	599 Count	837 Count	599 Count
1745120625	595 Count	833 Count	595 Count
1745117025	591 Count	829 Count	591 Count
1745113425	587 Count	825 Count	587 Count
1745109825	584 Count	822 Count	584 Count
1745106225	580 Count	818 Count	580 Count
1745102625	576 Count	814 Count	576 Count
1745099025	572 Count	810 Count	572 Count
1745095425	568 Count	806 Count	568 Count
1745091825	564 Count	802 Count	564 Count
1745088225	560 Count	798 Count	560 Count
1745084625	556 Count	794 Count	556 Count
1745081025	552 Count	790 Count	552 Count
1745077425	548 Count	786 Count	548 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)