EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9EWK-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9EWK-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1757901209	26 Count	220 Count
1757899405	25 Count	211 Count
1757897601	24 Count	201 Count
1757895797	23 Count	191 Count
1757893994	22 Count	174 Count
1757892190	21 Count	153 Count
1757886830	14 Count	132 Count
1757885026	13 Count	122 Count
1757883223	12 Count	112 Count
1757881419	11 Count	100 Count
1757879615	10 Count	82 Count
1757877811	9 Count	71 Count
1757876008	8 Count	62 Count
1757874204	7 Count	51 Count
1757872400	6 Count	40 Count
1757870596	5 Count	31 Count
1757865230	229 Count	997 Count
1757863426	228 Count	987 Count
1757861622	227 Count	973 Count
1757859819	226 Count	961 Count
1757858015	225 Count	944 Count
1757856211	224 Count	933 Count
1757854407	223 Count	921 Count
1757852604	222 Count	910 Count
1757850800	221 Count	891 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)