EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9EWK-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9EWK-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1758040270	109 Count	712 Count
1758038467	108 Count	699 Count
1758034859	106 Count	678 Count
1758033100	101 Count	669 Count
1758031296	100 Count	653 Count
1758029492	99 Count	643 Count
1758027689	98 Count	631 Count
1758025885	97 Count	620 Count
1758024081	96 Count	605 Count
1758022278	95 Count	590 Count
1758020474	94 Count	574 Count
1758018670	93 Count	564 Count
1758016867	92 Count	554 Count
1758015063	91 Count	544 Count
1758013259	90 Count	527 Count
1758011794	85 Count	527 Count
1758009990	84 Count	522 Count
1757983169	79 Count	522 Count
1757979562	77 Count	483 Count
1757977758	76 Count	452 Count
1757965379	71 Count	452 Count
1757963575	70 Count	450 Count
1757961772	69 Count	447 Count
1757959968	68 Count	445 Count
1757958164	67 Count	443 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)