EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789231808	13 Count	50 Count	4 Count
1789231564	12 Count	48 Count	4 Count
1789231075	9 Count	45 Count	3 Count
1789230831	8 Count	44 Count	3 Count
1789230586	7 Count	43 Count	3 Count
1789230342	6 Count	30 Count	3 Count
1789230098	3 Count	19 Count	1 Count
1789229853	2 Count	15 Count	1 Count
1789229609	1 Count	8 Count	1 Count
1789229364	605 Count	1006 Count	220 Count
1789229120	602 Count	1000 Count	218 Count
1789228876	601 Count	998 Count	218 Count
1789228631	600 Count	995 Count	218 Count
1789228387	599 Count	992 Count	218 Count
1789228143	597 Count	988 Count	217 Count
1789227898	596 Count	986 Count	217 Count
1789227654	595 Count	983 Count	217 Count
1789227409	592 Count	976 Count	215 Count
1789227165	591 Count	972 Count	215 Count
1789226921	590 Count	969 Count	215 Count
1789226677	589 Count	965 Count	215 Count
1789226432	586 Count	959 Count	213 Count
1789226188	585 Count	957 Count	213 Count
1789225943	584 Count	956 Count	213 Count
1789225454	580 Count	948 Count	211 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)