EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789094267	326 Count	492 Count	141 Count
1789094176	321 Count	492 Count	141 Count
1789093931	320 Count	488 Count	141 Count
1789093687	319 Count	485 Count	141 Count
1789093443	317 Count	482 Count	140 Count
1789093198	315 Count	480 Count	139 Count
1789092954	314 Count	478 Count	139 Count
1789092709	312 Count	476 Count	138 Count
1789092465	309 Count	473 Count	136 Count
1789092220	308 Count	469 Count	136 Count
1789091976	307 Count	466 Count	136 Count
1789091731	305 Count	463 Count	135 Count
1789091487	303 Count	461 Count	134 Count
1789091242	302 Count	460 Count	134 Count
1789090998	301 Count	455 Count	134 Count
1789090754	299 Count	453 Count	133 Count
1789090509	297 Count	448 Count	132 Count
1789090020	294 Count	445 Count	131 Count
1789089776	293 Count	444 Count	131 Count
1789089532	292 Count	442 Count	131 Count
1789089287	290 Count	438 Count	130 Count
1789089043	288 Count	434 Count	129 Count
1789088798	285 Count	430 Count	127 Count
1789088554	283 Count	427 Count	126 Count
1789088310	282 Count	425 Count	126 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)