EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767283176	279 Count	1013 Count	226 Count
1767281375	259 Count	928 Count	210 Count
1767279575	237 Count	833 Count	191 Count
1767274173	167 Count	595 Count	130 Count
1767272372	144 Count	526 Count	110 Count
1767270571	121 Count	457 Count	91 Count
1767268771	99 Count	376 Count	71 Count
1767265185	42 Count	167 Count	36 Count
1767263385	21 Count	85 Count	19 Count
1767261584	316 Count	1073 Count	263 Count
1767259783	294 Count	996 Count	244 Count
1767257982	273 Count	916 Count	227 Count
1767256181	251 Count	847 Count	209 Count
1767254381	230 Count	777 Count	191 Count
1767252580	209 Count	708 Count	174 Count
1767250779	188 Count	633 Count	157 Count
1767248979	167 Count	570 Count	139 Count
1767247178	144 Count	497 Count	121 Count
1767245377	125 Count	428 Count	105 Count
1767243577	105 Count	360 Count	88 Count
1767241776	87 Count	292 Count	73 Count
1767239975	65 Count	218 Count	55 Count
1767238175	43 Count	150 Count	37 Count
1767236374	22 Count	70 Count	19 Count
1767234573	293 Count	1021 Count	241 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)