EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1772247463	221 Count	836 Count	207 Count
1772245663	199 Count	744 Count	186 Count
1772243862	176 Count	663 Count	164 Count
1772242062	154 Count	587 Count	143 Count
1772240261	131 Count	492 Count	121 Count
1772238460	109 Count	408 Count	100 Count
1772234859	67 Count	247 Count	60 Count
1772233058	44 Count	163 Count	39 Count
1772231258	18 Count	76 Count	18 Count
1772229457	192 Count	1051 Count	184 Count
1772227656	174 Count	976 Count	167 Count
1772225856	154 Count	898 Count	148 Count
1772224055	126 Count	799 Count	121 Count
1772222254	106 Count	713 Count	102 Count
1772220454	87 Count	600 Count	84 Count
1772218653	67 Count	455 Count	65 Count
1772216856	48 Count	345 Count	47 Count
1772215056	28 Count	168 Count	28 Count
1772213254	158 Count	1078 Count	148 Count
1772211451	134 Count	931 Count	125 Count
1772209650	109 Count	802 Count	101 Count
1772207864	84 Count	636 Count	81 Count
1772206064	62 Count	453 Count	60 Count
1772204263	41 Count	249 Count	40 Count
1772202462	21 Count	124 Count	21 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)