EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785077044	44 Count	666 Count	38 Count
1785075243	39 Count	559 Count	34 Count
1785073442	34 Count	462 Count	30 Count
1785071641	24 Count	343 Count	21 Count
1785069841	15 Count	232 Count	13 Count
1785068040	10 Count	137 Count	9 Count
1785066239	4 Count	78 Count	4 Count
1785064439	89 Count	1005 Count	70 Count
1785062638	85 Count	942 Count	67 Count
1785060837	77 Count	874 Count	60 Count
1785059037	72 Count	809 Count	56 Count
1785057236	68 Count	744 Count	53 Count
1785055435	63 Count	680 Count	49 Count
1785053635	57 Count	608 Count	45 Count
1785051834	52 Count	541 Count	41 Count
1785050033	44 Count	472 Count	34 Count
1785048233	39 Count	406 Count	30 Count
1785044632	27 Count	273 Count	20 Count
1785042831	21 Count	211 Count	15 Count
1785041030	15 Count	143 Count	10 Count
1785039244	5 Count	72 Count	5 Count
1785037444	83 Count	1023 Count	72 Count
1785035643	77 Count	945 Count	67 Count
1785033842	71 Count	871 Count	62 Count
1785032041	65 Count	783 Count	57 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)