EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

2M0SBP-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 2M0SBP-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1757946251	24 Count	255 Count
1757944448	23 Count	244 Count
1757942644	22 Count	241 Count
1757940841	21 Count	229 Count
1757939038	20 Count	221 Count
1757937235	19 Count	216 Count
1757935432	18 Count	211 Count
1757933629	17 Count	206 Count
1757931826	16 Count	197 Count
1757930023	15 Count	171 Count
1757928831	14 Count	171 Count
1757927028	13 Count	146 Count
1757926620	12 Count	140 Count
1757925913	11 Count	140 Count
1757924110	10 Count	128 Count
1757922307	9 Count	116 Count
1757920504	8 Count	99 Count
1757918701	7 Count	87 Count
1757916898	6 Count	75 Count
1757915095	5 Count	63 Count
1757913292	4 Count	51 Count
1757911489	3 Count	39 Count
1757909686	2 Count	27 Count
1757907883	1 Count	15 Count
1757906080	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)