EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1767265398	29 Count	494 Count
1767263594	28 Count	477 Count
1767261791	27 Count	460 Count
1767259988	26 Count	439 Count
1767258185	25 Count	424 Count
1767256381	24 Count	405 Count
1767254578	22 Count	379 Count
1767252774	21 Count	363 Count
1767251013	20 Count	341 Count
1767249210	19 Count	316 Count
1767247406	18 Count	311 Count
1767245603	17 Count	300 Count
1767243799	16 Count	280 Count
1767241996	15 Count	269 Count
1767240193	14 Count	250 Count
1767238390	13 Count	243 Count
1767236586	12 Count	223 Count
1767234783	11 Count	210 Count
1767232979	10 Count	190 Count
1767231176	9 Count	151 Count
1767229415	8 Count	134 Count
1767227612	7 Count	116 Count
1767225808	6 Count	109 Count
1767224005	5 Count	100 Count
1767222201	4 Count	89 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)