EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1766340185	27 Count	779 Count
1766338381	26 Count	741 Count
1766336578	24 Count	691 Count
1766334774	22 Count	647 Count
1766332971	21 Count	594 Count
1766331167	20 Count	549 Count
1766329364	19 Count	487 Count
1766327560	17 Count	453 Count
1766325756	16 Count	406 Count
1766323953	15 Count	318 Count
1766322243	14 Count	263 Count
1766320439	12 Count	249 Count
1766318635	11 Count	196 Count
1766316832	10 Count	158 Count
1766315029	9 Count	103 Count
1766313225	7 Count	58 Count
1766311422	5 Count	26 Count
1766309618	4 Count	25 Count
1766307815	3 Count	10 Count
1766306011	0 Count	1 Count
1766304208	17 Count	1014 Count
1766302404	16 Count	996 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)