EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1789243152	13 Count	490 Count
1789241349	12 Count	445 Count
1789239546	11 Count	393 Count
1789237741	10 Count	350 Count
1789235976	7 Count	307 Count
1789234173	6 Count	262 Count
1789232369	5 Count	212 Count
1789230566	4 Count	168 Count
1789228763	1 Count	96 Count
1789226959	0 Count	57 Count
1789225156	28 Count	1026 Count
1789223352	27 Count	974 Count
1789221549	23 Count	916 Count
1789219745	22 Count	855 Count
1789217942	21 Count	800 Count
1789216138	20 Count	724 Count
1789214375	17 Count	670 Count
1789212572	16 Count	613 Count
1789210768	15 Count	547 Count
1789208965	14 Count	491 Count
1789207162	11 Count	424 Count
1789205358	10 Count	380 Count
1789203555	9 Count	330 Count
1789201751	8 Count	271 Count
1789199947	5 Count	198 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)