EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1778935550	25 Count	477 Count
1778933747	24 Count	472 Count
1778931943	23 Count	464 Count
1778930140	22 Count	462 Count
1778928340	21 Count	458 Count
1778926533	20 Count	451 Count
1778924730	19 Count	432 Count
1778922926	18 Count	422 Count
1778921123	17 Count	418 Count
1778919320	16 Count	398 Count
1778917557	15 Count	360 Count
1778915754	14 Count	329 Count
1778913950	13 Count	291 Count
1778912147	12 Count	253 Count
1778910344	7 Count	202 Count
1778908540	6 Count	158 Count
1778906737	2 Count	110 Count
1778904933	1 Count	64 Count
1778903130	0 Count	37 Count
1778901327	41 Count	1028 Count
1778899523	40 Count	993 Count
1778897720	39 Count	967 Count
1778895958	38 Count	948 Count
1778894155	37 Count	926 Count
1778892352	36 Count	895 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)