EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1APG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1APG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757844893	297 Count	94 Count	12 Count
1757844868	296 Count	94 Count	12 Count
1757844729	295 Count	94 Count	12 Count
1757842929	294 Count	92 Count	12 Count
1757841128	293 Count	90 Count	12 Count
1757839327	292 Count	89 Count	12 Count
1757837527	291 Count	89 Count	12 Count
1757835726	290 Count	89 Count	12 Count
1757833926	289 Count	89 Count	12 Count
1757830324	287 Count	86 Count	12 Count
1757828524	286 Count	85 Count	12 Count
1757826723	285 Count	82 Count	12 Count
1757824923	284 Count	80 Count	12 Count
1757823125	283 Count	78 Count	12 Count
1757821325	282 Count	77 Count	12 Count
1757819524	281 Count	74 Count	12 Count
1757817723	280 Count	73 Count	12 Count
1757815923	279 Count	71 Count	12 Count
1757814122	278 Count	70 Count	12 Count
1757812322	277 Count	67 Count	12 Count
1757810521	276 Count	64 Count	12 Count
1757808720	275 Count	61 Count	12 Count
1757806920	274 Count	59 Count	12 Count
1757805119	273 Count	57 Count	12 Count
1757803319	272 Count	55 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)