EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1APG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1APG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769965472	392 Count	607 Count	141 Count
1769963671	389 Count	595 Count	139 Count
1769961871	386 Count	584 Count	137 Count
1769960070	383 Count	573 Count	135 Count
1769958269	380 Count	551 Count	133 Count
1769956481	377 Count	537 Count	131 Count
1769954681	374 Count	525 Count	129 Count
1769952880	371 Count	513 Count	127 Count
1769951079	368 Count	482 Count	125 Count
1769949278	365 Count	451 Count	123 Count
1769947478	353 Count	399 Count	112 Count
1769945677	340 Count	376 Count	100 Count
1769943876	337 Count	361 Count	98 Count
1769942076	334 Count	347 Count	96 Count
1769940275	331 Count	336 Count	94 Count
1769938474	328 Count	324 Count	92 Count
1769936674	325 Count	315 Count	90 Count
1769934876	322 Count	302 Count	88 Count
1769933075	319 Count	291 Count	86 Count
1769931275	316 Count	279 Count	84 Count
1769929474	313 Count	268 Count	82 Count
1769927673	310 Count	256 Count	80 Count
1769925873	307 Count	245 Count	78 Count
1769924072	302 Count	233 Count	74 Count
1769922271	299 Count	222 Count	72 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)