EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9EMP-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757091520	5 Count	16 Count	4 Count
1757089720	2 Count	9 Count	2 Count
1757087919	176 Count	1006 Count	123 Count
1757086118	171 Count	978 Count	119 Count
1757084317	166 Count	949 Count	115 Count
1757082516	161 Count	920 Count	111 Count
1757080716	152 Count	869 Count	103 Count
1757078915	148 Count	835 Count	101 Count
1757077122	146 Count	825 Count	101 Count
1757075322	145 Count	818 Count	101 Count
1757073521	142 Count	807 Count	100 Count
1757071720	139 Count	786 Count	98 Count
1757069919	136 Count	766 Count	96 Count
1757068119	132 Count	746 Count	94 Count
1757066318	129 Count	731 Count	92 Count
1757064517	125 Count	704 Count	90 Count
1757062716	122 Count	678 Count	88 Count
1757060916	118 Count	646 Count	86 Count
1757059115	115 Count	626 Count	84 Count
1757057314	112 Count	602 Count	82 Count
1757055523	108 Count	576 Count	80 Count
1757053722	104 Count	547 Count	78 Count
1757051921	98 Count	507 Count	73 Count
1757050120	94 Count	481 Count	70 Count
1757048320	88 Count	456 Count	66 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)