EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8NCG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8NCG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1789246192	566 Count	303 Count
1789244392	561 Count	300 Count
1789242591	554 Count	297 Count
1789240790	549 Count	294 Count
1789238989	542 Count	291 Count
1789237188	538 Count	289 Count
1789235387	533 Count	286 Count
1789233596	528 Count	283 Count
1789231795	521 Count	280 Count
1789229995	516 Count	277 Count
1789228194	509 Count	274 Count
1789226393	504 Count	271 Count
1789224592	497 Count	268 Count
1789222791	492 Count	265 Count
1789220991	486 Count	262 Count
1789219190	480 Count	259 Count
1789217389	474 Count	256 Count
1789215588	468 Count	253 Count
1789213787	465 Count	250 Count
1789211995	459 Count	247 Count
1789210194	453 Count	244 Count
1789208394	447 Count	241 Count
1789206593	441 Count	238 Count
1789204792	435 Count	235 Count
1789202991	429 Count	232 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)