EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8NCG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8NCG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1793190113	302 Count	206 Count
1793188312	301 Count	203 Count
1793186520	294 Count	200 Count
1793184719	289 Count	197 Count
1793182918	282 Count	194 Count
1793181118	277 Count	191 Count
1793179317	270 Count	188 Count
1793177516	265 Count	185 Count
1793175715	258 Count	182 Count
1793173914	243 Count	163 Count
1793172114	203 Count	127 Count
1793170313	198 Count	124 Count
1793168512	180 Count	107 Count
1793166711	179 Count	104 Count
1793164919	172 Count	101 Count
1793163118	167 Count	98 Count
1793161317	160 Count	95 Count
1793159516	155 Count	92 Count
1793157715	148 Count	89 Count
1793155915	143 Count	86 Count
1793154114	136 Count	83 Count
1793152313	131 Count	80 Count
1793150513	124 Count	77 Count
1793148712	119 Count	74 Count
1793146911	115 Count	71 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)