EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1746948468	25 Count	98 Count	13 Count
1746947565	23 Count	90 Count	12 Count
1746946662	21 Count	83 Count	11 Count
1746945759	18 Count	74 Count	9 Count
1746944856	16 Count	65 Count	8 Count
1746943953	14 Count	60 Count	7 Count
1746943050	11 Count	52 Count	6 Count
1746942147	9 Count	46 Count	5 Count
1746941244	7 Count	36 Count	4 Count
1746940341	5 Count	28 Count	3 Count
1746939438	3 Count	17 Count	2 Count
1746938535	1 Count	9 Count	1 Count
1746937632	295 Count	1005 Count	221 Count
1746936729	293 Count	999 Count	220 Count
1746935826	291 Count	990 Count	219 Count
1746934923	288 Count	981 Count	217 Count
1746934020	286 Count	972 Count	216 Count
1746933117	283 Count	959 Count	214 Count
1746932214	281 Count	950 Count	213 Count
1746931311	279 Count	942 Count	212 Count
1746930408	276 Count	933 Count	210 Count
1746929505	274 Count	925 Count	209 Count
1746928602	272 Count	916 Count	208 Count
1746927699	270 Count	905 Count	207 Count
1746926868	268 Count	897 Count	206 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)