EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IQ9DM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IQ9DM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1756269298	323 Count	667 Count	297 Count
1756267495	311 Count	646 Count	286 Count
1756265691	302 Count	616 Count	278 Count
1756263887	292 Count	593 Count	269 Count
1756262084	284 Count	574 Count	262 Count
1756260281	273 Count	558 Count	252 Count
1756258477	260 Count	529 Count	240 Count
1756256674	248 Count	505 Count	229 Count
1756254919	236 Count	480 Count	218 Count
1756253115	224 Count	458 Count	207 Count
1756251312	213 Count	434 Count	197 Count
1756249508	200 Count	413 Count	185 Count
1756247705	186 Count	389 Count	172 Count
1756245902	174 Count	371 Count	161 Count
1756244098	161 Count	345 Count	149 Count
1756242295	149 Count	320 Count	138 Count
1756240492	137 Count	298 Count	127 Count
1756238688	125 Count	278 Count	116 Count
1756236885	114 Count	259 Count	106 Count
1756235082	103 Count	238 Count	96 Count
1756233309	90 Count	217 Count	84 Count
1756231506	79 Count	195 Count	74 Count
1756229702	66 Count	176 Count	62 Count
1756227899	53 Count	154 Count	50 Count
1756226096	40 Count	125 Count	38 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)