EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4HSE-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1756928254	663 Count	585 Count	233 Count
1756926454	661 Count	583 Count	232 Count
1756924653	660 Count	582 Count	232 Count
1756922853	658 Count	580 Count	231 Count
1756921052	657 Count	579 Count	231 Count
1756919251	655 Count	577 Count	230 Count
1756917451	654 Count	576 Count	230 Count
1756915650	652 Count	574 Count	229 Count
1756913850	651 Count	573 Count	229 Count
1756912049	649 Count	571 Count	228 Count
1756910248	648 Count	570 Count	228 Count
1756908454	642 Count	566 Count	227 Count
1756906653	641 Count	565 Count	227 Count
1756904853	639 Count	563 Count	226 Count
1756903052	638 Count	562 Count	226 Count
1756901252	636 Count	560 Count	225 Count
1756899451	635 Count	559 Count	225 Count
1756897651	633 Count	557 Count	224 Count
1756895851	632 Count	556 Count	224 Count
1756894050	630 Count	554 Count	223 Count
1756892249	629 Count	553 Count	223 Count
1756890448	627 Count	551 Count	222 Count
1756888648	626 Count	550 Count	222 Count
1756886853	620 Count	546 Count	221 Count
1756885053	619 Count	545 Count	221 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)