EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1767333832	641 Count	755 Count	504 Count
1767330231	638 Count	751 Count	502 Count
1767326630	634 Count	746 Count	499 Count
1767323029	631 Count	741 Count	497 Count
1767319428	628 Count	732 Count	495 Count
1767315827	625 Count	727 Count	493 Count
1767312226	622 Count	722 Count	491 Count
1767308625	619 Count	717 Count	489 Count
1767305024	611 Count	708 Count	482 Count
1767301424	608 Count	703 Count	480 Count
1767297823	605 Count	693 Count	478 Count
1767294222	602 Count	688 Count	476 Count
1767290620	598 Count	680 Count	473 Count
1767287019	594 Count	675 Count	470 Count
1767283419	591 Count	671 Count	468 Count
1767279818	588 Count	666 Count	466 Count
1767276217	584 Count	662 Count	463 Count
1767272616	579 Count	657 Count	459 Count
1767269015	572 Count	649 Count	453 Count
1767265413	567 Count	644 Count	449 Count
1767261812	563 Count	639 Count	446 Count
1767258212	558 Count	634 Count	442 Count
1767254611	553 Count	629 Count	438 Count
1767251010	548 Count	624 Count	434 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)