EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1769926965	528 Count	935 Count	366 Count
1769923365	525 Count	928 Count	364 Count
1769919764	522 Count	921 Count	362 Count
1769916163	519 Count	914 Count	360 Count
1769912562	516 Count	907 Count	358 Count
1769908961	513 Count	901 Count	356 Count
1769905360	510 Count	896 Count	354 Count
1769901758	507 Count	891 Count	352 Count
1769898158	504 Count	885 Count	350 Count
1769894557	502 Count	882 Count	349 Count
1769890956	499 Count	878 Count	347 Count
1769887355	496 Count	875 Count	345 Count
1769883754	493 Count	871 Count	343 Count
1769880153	490 Count	866 Count	341 Count
1769876553	487 Count	859 Count	339 Count
1769872951	484 Count	853 Count	337 Count
1769869349	481 Count	847 Count	335 Count
1769865749	478 Count	843 Count	333 Count
1769862148	475 Count	837 Count	331 Count
1769858547	472 Count	830 Count	329 Count
1769854947	469 Count	823 Count	327 Count
1769851346	466 Count	816 Count	325 Count
1769847744	463 Count	810 Count	323 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)