EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1773196033	32 Count	51 Count	23 Count
1773192432	29 Count	45 Count	21 Count
1773188831	25 Count	39 Count	18 Count
1773185230	22 Count	34 Count	16 Count
1773181629	18 Count	28 Count	13 Count
1773178028	15 Count	25 Count	11 Count
1773174427	12 Count	21 Count	9 Count
1773170826	9 Count	16 Count	7 Count
1773167225	5 Count	10 Count	4 Count
1773163624	3 Count	6 Count	3 Count
1773160023	773 Count	1006 Count	536 Count
1773156422	770 Count	1000 Count	534 Count
1773152821	767 Count	995 Count	532 Count
1773149220	765 Count	990 Count	531 Count
1773145619	761 Count	984 Count	528 Count
1773142019	758 Count	978 Count	526 Count
1773138418	754 Count	972 Count	523 Count
1773134817	751 Count	968 Count	521 Count
1773131216	744 Count	959 Count	515 Count
1773127615	742 Count	956 Count	514 Count
1773124014	738 Count	951 Count	511 Count
1773120414	735 Count	946 Count	509 Count
1773116813	732 Count	941 Count	507 Count
1773113211	729 Count	936 Count	505 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)