EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757854960	122 Count	378 Count	69 Count
1757853159	120 Count	364 Count	68 Count
1757851358	118 Count	355 Count	67 Count
1757849558	116 Count	350 Count	66 Count
1757847757	114 Count	344 Count	65 Count
1757845956	112 Count	341 Count	64 Count
1757844155	110 Count	337 Count	63 Count
1757842362	108 Count	332 Count	62 Count
1757840562	106 Count	329 Count	61 Count
1757838761	104 Count	326 Count	60 Count
1757836960	102 Count	322 Count	59 Count
1757835159	100 Count	319 Count	58 Count
1757833359	98 Count	315 Count	57 Count
1757831558	96 Count	311 Count	56 Count
1757829757	94 Count	295 Count	55 Count
1757827957	92 Count	290 Count	54 Count
1757826156	90 Count	287 Count	53 Count
1757824355	88 Count	283 Count	52 Count
1757822554	86 Count	279 Count	51 Count
1757800823	73 Count	239 Count	39 Count
1757799020	71 Count	235 Count	38 Count
1757797215	69 Count	231 Count	37 Count
1757796732	68 Count	231 Count	37 Count
1757796683	67 Count	231 Count	37 Count
1757796658	66 Count	231 Count	37 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)