EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1756550173	243 Count	916 Count	131 Count
1756548373	241 Count	911 Count	130 Count
1756546572	240 Count	906 Count	130 Count
1756544776	238 Count	902 Count	129 Count
1756542975	236 Count	897 Count	128 Count
1756541175	230 Count	884 Count	123 Count
1756539374	226 Count	876 Count	120 Count
1756537573	224 Count	871 Count	119 Count
1756535773	222 Count	866 Count	118 Count
1756533972	220 Count	862 Count	117 Count
1756532171	218 Count	856 Count	116 Count
1756530370	216 Count	851 Count	115 Count
1756528570	214 Count	842 Count	114 Count
1756526769	212 Count	836 Count	113 Count
1756524968	210 Count	831 Count	112 Count
1756523189	208 Count	825 Count	111 Count
1756521388	206 Count	819 Count	110 Count
1756519587	204 Count	813 Count	109 Count
1756517786	202 Count	808 Count	108 Count
1756515986	200 Count	802 Count	107 Count
1756514185	198 Count	797 Count	106 Count
1756512384	196 Count	792 Count	105 Count
1756510583	194 Count	787 Count	104 Count
1756508783	192 Count	782 Count	103 Count
1756506982	190 Count	777 Count	102 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)