EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773746663	411 Count	615 Count	150 Count
1773744862	409 Count	613 Count	149 Count
1773743061	407 Count	611 Count	148 Count
1773741261	405 Count	609 Count	147 Count
1773739460	402 Count	605 Count	145 Count
1773737659	399 Count	600 Count	143 Count
1773735858	396 Count	597 Count	141 Count
1773734057	395 Count	588 Count	141 Count
1773732257	393 Count	585 Count	140 Count
1773730456	390 Count	576 Count	138 Count
1773728655	388 Count	571 Count	137 Count
1773726863	387 Count	569 Count	137 Count
1773725062	384 Count	562 Count	135 Count
1773723261	381 Count	550 Count	133 Count
1773721460	379 Count	547 Count	132 Count
1773719660	378 Count	547 Count	132 Count
1773717859	377 Count	545 Count	132 Count
1773716058	376 Count	545 Count	132 Count
1773714258	374 Count	542 Count	131 Count
1773712457	372 Count	540 Count	130 Count
1773710656	371 Count	538 Count	130 Count
1773708855	370 Count	538 Count	130 Count
1773707055	369 Count	538 Count	130 Count
1773705262	368 Count	538 Count	130 Count
1773703461	366 Count	537 Count	129 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)