EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777078533	507 Count	568 Count	153 Count
1777076732	506 Count	566 Count	153 Count
1777074940	503 Count	561 Count	151 Count
1777073139	501 Count	557 Count	150 Count
1777071338	499 Count	555 Count	149 Count
1777069538	496 Count	550 Count	147 Count
1777067737	494 Count	546 Count	146 Count
1777065936	493 Count	545 Count	146 Count
1777064136	492 Count	544 Count	146 Count
1777062335	491 Count	542 Count	146 Count
1777060534	490 Count	538 Count	146 Count
1777058733	488 Count	536 Count	145 Count
1777056933	485 Count	531 Count	143 Count
1777055132	483 Count	501 Count	142 Count
1777053339	481 Count	493 Count	141 Count
1777051539	479 Count	490 Count	140 Count
1777049738	477 Count	488 Count	139 Count
1777047937	475 Count	486 Count	138 Count
1777046136	473 Count	483 Count	137 Count
1777044336	472 Count	480 Count	137 Count
1777042535	471 Count	479 Count	137 Count
1777040734	470 Count	478 Count	137 Count
1777038934	469 Count	477 Count	137 Count
1777037133	468 Count	476 Count	137 Count
1777035332	467 Count	474 Count	137 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)