EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4GMY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4GMY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777545757	855 Count	13 Count	13 Count
1777543951	853 Count	13 Count	13 Count
1777538533	847 Count	13 Count	13 Count
1777537630	846 Count	13 Count	13 Count
1777524155	827 Count	13 Count	13 Count
1777523252	826 Count	13 Count	13 Count
1777522349	825 Count	13 Count	13 Count
1777519640	822 Count	13 Count	13 Count
1777518737	821 Count	13 Count	13 Count
1777517833	820 Count	13 Count	13 Count
1777516931	819 Count	13 Count	13 Count
1777516027	818 Count	13 Count	13 Count
1777515124	817 Count	13 Count	13 Count
1777514221	816 Count	13 Count	13 Count
1777513318	815 Count	13 Count	13 Count
1777510609	812 Count	13 Count	13 Count
1777508803	810 Count	13 Count	13 Count
1777503455	800 Count	13 Count	13 Count
1777498037	794 Count	13 Count	13 Count
1777497134	793 Count	13 Count	13 Count
1777496231	792 Count	13 Count	13 Count
1777495328	791 Count	13 Count	13 Count
1777494424	790 Count	13 Count	13 Count
1777493521	789 Count	13 Count	13 Count
1777492618	788 Count	13 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)