EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9SRC-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9SRC-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1757870676	4 Count	54 Count
1757870075	2 Count	35 Count
1757869474	0 Count	20 Count
1757868873	54 Count	1001 Count
1757868275	53 Count	986 Count
1757867672	52 Count	966 Count
1757867071	51 Count	945 Count
1757866471	50 Count	922 Count
1757865870	49 Count	902 Count
1757865269	48 Count	875 Count
1757864669	47 Count	859 Count
1757864094	46 Count	834 Count
1757863493	45 Count	812 Count
1757862892	44 Count	797 Count
1757862292	43 Count	780 Count
1757861691	42 Count	760 Count
1757861090	41 Count	746 Count
1757860489	40 Count	722 Count
1757859889	39 Count	711 Count
1757859288	38 Count	695 Count
1757858687	37 Count	679 Count
1757858087	36 Count	661 Count
1757857485	35 Count	647 Count
1757856884	34 Count	615 Count
1757856284	33 Count	588 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)