EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9SRC-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9SRC-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1755770039	52 Count	444 Count
1755768256	48 Count	362 Count
1755767655	47 Count	343 Count
1755767054	45 Count	325 Count
1755766453	43 Count	304 Count
1755765852	42 Count	283 Count
1755765252	40 Count	267 Count
1755764651	38 Count	258 Count
1755764050	37 Count	247 Count
1755762857	33 Count	219 Count
1755762253	32 Count	210 Count
1755761052	28 Count	186 Count
1755759845	25 Count	151 Count
1755759244	23 Count	139 Count
1755758644	22 Count	130 Count
1755758043	20 Count	120 Count
1755757442	18 Count	111 Count
1755756842	17 Count	101 Count
1755756241	15 Count	93 Count
1755755640	13 Count	85 Count
1755755039	12 Count	71 Count
1755754439	10 Count	50 Count
1755753838	8 Count	40 Count
1755753237	6 Count	33 Count
1755752636	4 Count	17 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)