EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IW9GTR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW9GTR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1757936418	298 Count	689 Count	229 Count
1757935209	290 Count	671 Count	223 Count
1757934004	283 Count	639 Count	218 Count
1757932802	277 Count	616 Count	214 Count
1757931582	270 Count	599 Count	209 Count
1757930876	267 Count	592 Count	208 Count
1757929667	259 Count	571 Count	202 Count
1757928462	254 Count	540 Count	199 Count
1757927248	248 Count	522 Count	195 Count
1757926039	239 Count	504 Count	188 Count
1757924830	226 Count	486 Count	177 Count
1757923626	219 Count	471 Count	172 Count
1757922413	210 Count	445 Count	165 Count
1757921208	201 Count	425 Count	158 Count
1757919999	197 Count	408 Count	156 Count
1757919138	189 Count	393 Count	150 Count
1757917909	181 Count	374 Count	144 Count
1757916680	176 Count	362 Count	141 Count
1757915451	166 Count	344 Count	133 Count
1757914223	159 Count	323 Count	128 Count
1757912994	152 Count	305 Count	123 Count
1757911765	143 Count	286 Count	116 Count
1757910556	130 Count	263 Count	105 Count
1757909346	118 Count	246 Count	95 Count
1757908127	106 Count	223 Count	85 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)