EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IW9GTR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW9GTR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1764960095	534 Count	832 Count	473 Count
1764958886	517 Count	806 Count	458 Count
1764957677	502 Count	787 Count	445 Count
1764956468	487 Count	763 Count	432 Count
1764955259	470 Count	729 Count	417 Count
1764954050	454 Count	702 Count	403 Count
1764952841	436 Count	671 Count	387 Count
1764951632	418 Count	644 Count	371 Count
1764950424	400 Count	615 Count	355 Count
1764949214	384 Count	586 Count	341 Count
1764948004	371 Count	558 Count	330 Count
1764946793	354 Count	523 Count	315 Count
1764945583	335 Count	496 Count	298 Count
1764944374	319 Count	473 Count	284 Count
1764943165	306 Count	447 Count	273 Count
1764942123	291 Count	420 Count	260 Count
1764940914	271 Count	390 Count	242 Count
1764939705	252 Count	364 Count	225 Count
1764938497	233 Count	338 Count	208 Count
1764937288	214 Count	309 Count	191 Count
1764936078	196 Count	283 Count	175 Count
1764934869	176 Count	256 Count	157 Count
1764933661	159 Count	232 Count	142 Count
1764932452	141 Count	208 Count	126 Count
1764931243	119 Count	176 Count	106 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)