EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1767301469	72 Count	792 Count
1767299665	71 Count	775 Count
1767297862	70 Count	759 Count
1767296058	69 Count	747 Count
1767294255	68 Count	735 Count
1767292493	63 Count	721 Count
1767290689	62 Count	710 Count
1767288886	61 Count	696 Count
1767287081	60 Count	681 Count
1767285278	59 Count	666 Count
1767283474	58 Count	653 Count
1767281671	57 Count	643 Count
1767279867	56 Count	628 Count
1767278064	55 Count	604 Count
1767276260	54 Count	580 Count
1767274455	53 Count	564 Count
1767272652	52 Count	547 Count
1767270888	47 Count	536 Count
1767269085	46 Count	522 Count
1767267281	45 Count	497 Count
1767265478	44 Count	480 Count
1767263674	43 Count	465 Count
1767261871	42 Count	450 Count
1767260067	41 Count	438 Count
1767258264	40 Count	423 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)