EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764946713	7 Count	126 Count
1764944910	6 Count	110 Count
1764943106	5 Count	96 Count
1764941303	4 Count	87 Count
1764939499	3 Count	76 Count
1764937696	2 Count	62 Count
1764935892	1 Count	48 Count
1764934088	0 Count	26 Count
1764932285	86 Count	1010 Count
1764930481	85 Count	989 Count
1764928718	80 Count	978 Count
1764926915	79 Count	959 Count
1764925111	78 Count	931 Count
1764923307	77 Count	907 Count
1764921504	76 Count	893 Count
1764919700	75 Count	881 Count
1764917897	74 Count	869 Count
1764916093	73 Count	857 Count
1764914290	72 Count	843 Count
1764912486	71 Count	832 Count
1764910682	70 Count	800 Count
1764908879	69 Count	773 Count
1764907115	64 Count	763 Count
1764905311	63 Count	751 Count
1764903507	62 Count	740 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)