EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789206958	202 Count	530 Count	153 Count
1789206354	196 Count	521 Count	148 Count
1789205749	192 Count	507 Count	145 Count
1789205140	188 Count	503 Count	142 Count
1789204545	182 Count	494 Count	137 Count
1789203930	177 Count	480 Count	133 Count
1789203325	174 Count	468 Count	131 Count
1789202721	172 Count	464 Count	130 Count
1789202116	168 Count	452 Count	127 Count
1789201511	165 Count	436 Count	125 Count
1789200907	162 Count	416 Count	123 Count
1789200302	157 Count	394 Count	119 Count
1789199697	154 Count	381 Count	117 Count
1789199093	149 Count	375 Count	113 Count
1789197278	137 Count	355 Count	104 Count
1789196673	134 Count	348 Count	102 Count
1789196068	132 Count	343 Count	101 Count
1789194859	125 Count	331 Count	96 Count
1789194254	120 Count	322 Count	92 Count
1789193045	112 Count	301 Count	86 Count
1789192440	107 Count	286 Count	82 Count
1789191834	104 Count	281 Count	80 Count
1789191229	99 Count	275 Count	76 Count
1789190624	96 Count	270 Count	74 Count
1789189415	86 Count	256 Count	66 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)