EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2SIX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2SIX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761787960	7 Count	471 Count	7 Count
1761787360	7 Count	470 Count	7 Count
1761786760	7 Count	466 Count	7 Count
1761786160	7 Count	464 Count	7 Count
1761785560	7 Count	462 Count	7 Count
1761784961	7 Count	459 Count	7 Count
1761784361	7 Count	456 Count	7 Count
1761783760	7 Count	453 Count	7 Count
1761783160	7 Count	449 Count	7 Count
1761782560	7 Count	445 Count	7 Count
1761781960	7 Count	444 Count	7 Count
1761781360	7 Count	442 Count	7 Count
1761780760	7 Count	439 Count	7 Count
1761780160	7 Count	438 Count	7 Count
1761779560	7 Count	435 Count	7 Count
1761778960	7 Count	430 Count	7 Count
1761778360	7 Count	422 Count	7 Count
1761777761	2 Count	405 Count	2 Count
1761777161	2 Count	403 Count	2 Count
1761776561	2 Count	400 Count	2 Count
1761775961	2 Count	398 Count	2 Count
1761775361	2 Count	394 Count	2 Count
1761774761	2 Count	393 Count	2 Count
1761774161	2 Count	391 Count	2 Count
1761773561	2 Count	388 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)