EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757858252	17 Count	367 Count	13 Count
1757856163	16 Count	366 Count	13 Count
1757854363	12 Count	289 Count	10 Count
1757852562	8 Count	197 Count	7 Count
1757850761	3 Count	98 Count	3 Count
1757848960	74 Count	1007 Count	64 Count
1757847159	69 Count	848 Count	60 Count
1757845907	68 Count	847 Count	60 Count
1757844116	58 Count	744 Count	51 Count
1757842315	49 Count	665 Count	43 Count
1757840514	47 Count	592 Count	42 Count
1757838714	37 Count	494 Count	33 Count
1757836912	11 Count	291 Count	8 Count
1757835112	9 Count	206 Count	7 Count
1757833311	6 Count	151 Count	5 Count
1757831510	3 Count	74 Count	3 Count
1757829709	65 Count	1052 Count	48 Count
1757827908	61 Count	985 Count	45 Count
1757826108	57 Count	924 Count	42 Count
1757824307	54 Count	844 Count	40 Count
1757822515	49 Count	775 Count	36 Count
1757820714	46 Count	725 Count	34 Count
1757818913	40 Count	644 Count	29 Count
1757817112	36 Count	586 Count	26 Count
1757815311	32 Count	533 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)