EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1754182689	49 Count	678 Count	42 Count
1754180889	41 Count	597 Count	35 Count
1754179088	35 Count	513 Count	30 Count
1754177287	27 Count	418 Count	23 Count
1754175486	21 Count	328 Count	18 Count
1754173685	15 Count	250 Count	13 Count
1754171885	9 Count	178 Count	8 Count
1754170084	4 Count	100 Count	4 Count
1754168283	86 Count	1069 Count	70 Count
1754166482	81 Count	989 Count	66 Count
1754143648	80 Count	989 Count	66 Count
1754141847	71 Count	924 Count	58 Count
1754140051	67 Count	867 Count	55 Count
1754138250	60 Count	807 Count	49 Count
1754136449	55 Count	761 Count	45 Count
1754134648	50 Count	710 Count	41 Count
1754132848	45 Count	650 Count	37 Count
1754131047	41 Count	601 Count	34 Count
1754129246	36 Count	473 Count	30 Count
1754127445	29 Count	413 Count	24 Count
1754125644	24 Count	346 Count	20 Count
1754123844	19 Count	269 Count	16 Count
1754122043	14 Count	209 Count	12 Count
1754120242	9 Count	95 Count	8 Count
1754118819	8 Count	95 Count	8 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)