EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8KSR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8KSR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789236050	0 Count	0 Count	0 Count
1789234260	814 Count	993 Count	814 Count
1789232460	801 Count	974 Count	801 Count
1789230660	786 Count	955 Count	786 Count
1789228860	773 Count	937 Count	773 Count
1789227060	759 Count	919 Count	759 Count
1789225259	723 Count	878 Count	723 Count
1789223458	688 Count	838 Count	688 Count
1789221658	649 Count	794 Count	649 Count
1789219858	614 Count	755 Count	614 Count
1789218058	562 Count	690 Count	562 Count
1789216257	522 Count	645 Count	522 Count
1789214457	479 Count	597 Count	479 Count
1789212651	467 Count	579 Count	467 Count
1789210851	453 Count	559 Count	453 Count
1789209051	428 Count	529 Count	428 Count
1789207251	370 Count	466 Count	370 Count
1789205450	354 Count	445 Count	354 Count
1789203650	330 Count	415 Count	330 Count
1789201850	296 Count	376 Count	296 Count
1789200050	252 Count	326 Count	252 Count
1789198250	204 Count	273 Count	204 Count
1789196450	192 Count	256 Count	192 Count
1789194648	175 Count	234 Count	175 Count
1789192848	161 Count	214 Count	161 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)