EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8KSR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8KSR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1788962441	775 Count	1012 Count	775 Count
1788960641	762 Count	994 Count	762 Count
1788958841	744 Count	970 Count	744 Count
1788957041	716 Count	936 Count	716 Count
1788955240	673 Count	888 Count	673 Count
1788953442	652 Count	864 Count	652 Count
1788951642	639 Count	846 Count	639 Count
1788949842	624 Count	825 Count	624 Count
1788948042	603 Count	798 Count	603 Count
1788946241	587 Count	777 Count	587 Count
1788944441	572 Count	757 Count	572 Count
1788942641	562 Count	741 Count	562 Count
1788940841	548 Count	721 Count	548 Count
1788939041	534 Count	702 Count	534 Count
1788937241	520 Count	682 Count	520 Count
1788935441	502 Count	659 Count	502 Count
1788933641	486 Count	637 Count	486 Count
1788931840	471 Count	607 Count	471 Count
1788930040	453 Count	577 Count	453 Count
1788928240	437 Count	557 Count	437 Count
1788926440	418 Count	533 Count	418 Count
1788924639	402 Count	512 Count	402 Count
1788922839	383 Count	488 Count	383 Count
1788921039	365 Count	464 Count	365 Count
1788919239	345 Count	438 Count	345 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)