EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789245806	12 Count	229 Count	12 Count
1789244005	135 Count	1090 Count	122 Count
1789242205	117 Count	969 Count	105 Count
1789240404	101 Count	859 Count	91 Count
1789238602	85 Count	733 Count	76 Count
1789236801	75 Count	602 Count	67 Count
1789222140	74 Count	602 Count	67 Count
1789220340	64 Count	521 Count	59 Count
1789218539	47 Count	404 Count	43 Count
1789216738	27 Count	271 Count	25 Count
1789214937	13 Count	140 Count	13 Count
1789213137	167 Count	1094 Count	153 Count
1789211336	149 Count	960 Count	137 Count
1789209535	131 Count	841 Count	120 Count
1789207744	112 Count	708 Count	103 Count
1789205944	92 Count	571 Count	85 Count
1789204143	73 Count	462 Count	67 Count
1789202342	55 Count	349 Count	51 Count
1789200541	35 Count	245 Count	32 Count
1789198740	23 Count	168 Count	22 Count
1789196940	13 Count	91 Count	13 Count
1789195139	174 Count	1014 Count	160 Count
1789193338	160 Count	928 Count	148 Count
1789191537	145 Count	831 Count	134 Count
1789189737	128 Count	733 Count	119 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)