EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785269904	95 Count	674 Count	86 Count
1785268103	75 Count	563 Count	67 Count
1785266302	63 Count	478 Count	57 Count
1785264501	53 Count	377 Count	48 Count
1785262701	42 Count	283 Count	38 Count
1785260900	30 Count	193 Count	28 Count
1785259099	20 Count	89 Count	19 Count
1785257298	1 Count	2 Count	1 Count
1785255506	136 Count	981 Count	117 Count
1785253705	130 Count	920 Count	112 Count
1785251905	122 Count	871 Count	107 Count
1785250104	113 Count	806 Count	101 Count
1785248303	106 Count	743 Count	95 Count
1785246502	98 Count	678 Count	88 Count
1785244701	49 Count	501 Count	41 Count
1785242901	44 Count	434 Count	37 Count
1785241100	36 Count	368 Count	30 Count
1785239299	29 Count	300 Count	24 Count
1785237498	24 Count	227 Count	20 Count
1785235698	16 Count	171 Count	13 Count
1785233905	12 Count	110 Count	10 Count
1785232105	6 Count	57 Count	6 Count
1785230304	112 Count	1038 Count	99 Count
1785228503	105 Count	982 Count	93 Count
1785226702	95 Count	908 Count	85 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)