EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8MBR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8MBR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1792923678	319 Count	772 Count
1792921878	291 Count	687 Count
1792920077	257 Count	622 Count
1792918276	221 Count	529 Count
1792916475	192 Count	457 Count
1792914682	165 Count	398 Count
1792912881	142 Count	340 Count
1792911081	118 Count	294 Count
1792909280	82 Count	206 Count
1792907479	57 Count	141 Count
1792905679	32 Count	77 Count
1792903878	427 Count	1010 Count
1792902077	400 Count	939 Count
1792900277	371 Count	877 Count
1792898476	342 Count	806 Count
1792896675	311 Count	743 Count
1792894875	284 Count	673 Count
1792893082	255 Count	607 Count
1792891281	230 Count	545 Count
1792889480	199 Count	480 Count
1792887680	167 Count	398 Count
1792885879	144 Count	350 Count
1792884078	111 Count	286 Count
1792882277	84 Count	208 Count
1792880477	57 Count	147 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)